Table of Contents
Advertisement
Also,becertain thesmaller f rontwheels andthelarger
rearwheels aremounted c orrectly t othefrontandrear
ofthemower a sshown inFigure 1.
Rear Wheel
Hubcap Assembly
Front Wheel _IF-_
Hubcap Assembly "_"
Right Front View
Cutting Height Positions
low
Medium
High
Figure 1
Assembling Handle
Installingthe LowerHandles(Hardware A)
•
Insert long end of the lower handle into the handle
base. Make certain the small hole in the end of the
handle is lined up with the hole in handle base.
•
Using one of the two longer self tapping screws
from the hardware pack, insert the screw through
the tooth washer, flat washer, and the handle cap
as shown in Figure 2.
•
Align the handle cap so it rests flush against the
handle base, and tighten the screw into the lower
handle using a phillips screwdriver.
•
Repeat this step for the remaining lower handle.
Once both lower handles are installed, insert the
lower handle plugs into the upper ends of the lower
handles as shown in Figure 2.
Lower Handle I
Plug
Lower
Flat Washer
f
jTooth
_ _Washer
Self Tapping
Screw
Figure 2
Installingthe UpperHandle(Hardware B)
•
Standing behind the lawnmower with the upper
handle, make certain the two holes that will hold the
blade / motor control are on the right hand side.
See Figure 3 for proper alignment of upper handle.
Blade /
Upper Handle \\
Cord Insulator
Hex
Lock
Washer
Hex Nut
Lower Handle
Figure 3
Align the holes in the lower handle with those of the
upper handle and insert the hex and handle bolts
through both holes as shown in Figure 3.
Advertisement
Table of Contents
