Table of Contents
Advertisement
SECTION 6: MAKING ADJUSTMENTS
,_
WARNING:
Never attempt to make any
adjustments
while
the
engine
is running,
except
where
specified
in the
operator's
manual.
WARNING:
Disconnect
the spark
plug
wire(s) and ground against the engine before
performing
any
adjustments,
repairs
or
maintenance.
Loosen the two jam nuts on the rear side of the
deck stabilizer bracket. See Figure 9A.
Locate the two lock nuts on the opposite side of the
stabilizer bracket. See Figure 9A. Tighten the lock
nuts to raise the front of the deck; loosen the lock
nuts to lower the front of the deck.
Retighten the two jam nuts loosened earlier when
proper adjustment is achieved.
Side to Side
Leveling the Deck
NOTE:
Check
the
tractor's
tire pressure
before
performing
any deck leveling
adjustments.
Refer to
Tires on page 19 for information regarding tire pressure.
Front To Rear
The front of the cutting deck is supported by a stabilizer
bar that can adjusted to level the deck from front to rear.
The front of the deck should be between 1!4-inch and
3/8-inch lower than the rear of the deck. Adjust if
necessary as follows:
With the tractor parked on a firm, level surface,
place the deck lift lever in the top notch (highest
position) and rotate the blade nearest the discharge
chute so that it is parallel with the tractor.
Measure the distance from the front of the blade tip
to the ground and the rear of the blade tip to the
ground.
The first measurement taken should be between
1/4" and 3/8" less than the second measurement.
Determine the approximate distance necessary for
proper adjustment and proceed, if necessary, to the
next step.
AI
Lock
Nuts
If the cutting deck appears to be mowing unevenly, a
side to side adjustment can be performed. Adjust if
necessary as follows:
With the tractor parked on a firm, level surface,
place the deck lift lever in the top notch (highest
position) and rotate both blades so that they are
perpendicular with the tractor.
Measure the distance from the outside of the left
blade tip to the ground and the distance from the
outside of the right blade tip to the ground. Both
measurements taken should be equal. If they're
not, proceed to the next step.
Loosen, but do NOT remove, the hex cap screw on
the left deck hanger bracket. See Figure 9B.
Balance the deck by using a wrench to turn the
adjustment gear (found immediately behind the hex
cap screw just loosened) clockwise/up or
counterclockwise/down.
The deck is properly balanced when both blade tip
measurements taken earlier are equal.
Retighten the hex cap screw on the left deck
hanger bracket when proper adjustment is
achieved.
Stabilizer
Bracket
Deck
FRONT TO REAR
SIDE TO SIDE
Adjustment Gear
Hex Cap Screw
Figure 9
16
Hide quick links:
Advertisement
Table of Contents
