Start The Dryer; Indicator Lights; Drum Light - Maytag LDE5914AAL User Manual

_ccordlngto model.
slightly wrinkled from a crowded closet or suitcase
or from sitting in the dryer after the cycle is
complete. It provides 10 minutes of heated
tumbling and 5 minutes of cool down.
DAMP DRY -- To partially dry items to a damp
state, select "Damp Dry" on the Time Dry portion
of the controls. The clothes will tumble in heated
air for approximately 20 minutes, then cool air for
5 minutes.
AIR FLUFF-- Turn the temperature selector knob
to AIR FLUFF and set the desired number of
minutes on the Time Dry portion of the dial. This
provides tumbling without heat.
NOTE:
The dial will not advance at a specific
rate during the cycle. At first, the dial
may not advance at all. Toward the end
of the cycle (when the articles begin to
dry) the dial will advance at a more
regular rate and much more quickly. This
is normal operation and is not a reason
for concern.
Push the Button to Start
This dryer is designed so that it will not operate
when the door is open. If the door is opened
before the cycle is complete, the door must be
closed and the start button pushed.
Indicator Lights
DRYNESSMONITOR
Indicator lights in the dryness monitor will display
when an electronic dry cycle is in operation. The
top light wilt blink on and off. As loads dry, there
will be longer pauses between each blink. No
lights will display during Time Dry.
The bottom light in the monitor will remain on until
the cool down portion of the cycle starts. During
cool down the dryer continues to tumble the toad
in unheated air to help minimize wrinkling.
NOTE: The top monitor light may not blink when
small loads of heavy, bulky items are
dried, such as large rugs or sweaters.
ON LIGHT (Not on at! models)
This indicator light stays on throughout the cycle to
let you know the dryer is operating.
Drum Light
(Not on oil models)
The drum light comes on whenever the door is
opened. Close the door to turn off the light.
To change the drum light, follow these steps:
1. Unplug or disconnect the dryer.
2. Unscrew the bulb by turning counterclockwise.
3. Replace it with a 7 watt, 120 volt candelabra
base bulb (7C7).
4. Reconnect the power to the dryer.
PAGE 5