Raising The Presser Bar Lifter; Removing The Work From The Machine And Cutting The Threadis - Pfaff creative 1472 Instruction Book

Important!
When the main switch is pressed to
switch the machine on, the sewing
lamp lights up
When the machine is switched off by
pressing the main switch, removing the
mains plug or by power failure, the
program memory in the computer is
saved by a battery back-up. When the
machine is switched on again, program
00 (straight stitch with needle in
middle position) appears. All program
combinations entered into any
memory are retained automatically.
If a program is entered during sewing.
it will not become effective until the
machine is stopped and the foot con
trol is pressed again.
The stitch width and stitch length can
be changed during sewing
For bobbin winding disengage the
sewing action.
After bobbin winding engage the
sewing action again.
Owing to the use of electronic compo
nents this machine becomes warm
during operation. This is quite normal
and of no consequence.
Batteries:
When the machine is switched on and
the word "batterY" is displayed contin
uously in four languages, the battery
tension is no longer sufficient. The
batteries must then be replaced by
new ones (see page 43). When a pro
gram is selected the word 'battery"
disappears from the display.
Raising the presser bar lifter:
When you have finished a seam the
needle must be fully raised. Then raise
presser bar lifter 17.
J
H
Removing the work from the machine
and cutting the threads:
Remove the material to the rear and
pull the threads in sewing direction
into thread cutter 37 in order to cut
them
26
:'
2