Advertisement
Available languages
Available languages
5.7 CUft DRYER (STYLE 3)iNSTRUCTiONS
(WHITE KiT)
Cs) Attaching
dryer (style 3) mounting
hardware
1. Use the following instructions for mounting this type of dryer to
the pedestal:
Dryer cabinet (style 3)
with 2 indents on side
and 4 inch knockout
for
side venting.
\
-
Dryer console (style 3) has
mechanical
style timer.
_2
plastic hole
/
plugs toward
bottom
t panel
2. Remove 2 plastic hole plugs toward bottom of front panel.
3. Attach each front clip to outer-most set of holes with 2 screws.
4. Insert "B" tab of each rear bracket into the front slots on rear of
pedestal. Orient bracket outward for "style 3" dryer mounting.
{aBb'-_J
front
_\
outward
5.
Install 2 screws through each rear bracket into aligning pedestal
holes.
Ds) Mounting
dryer (style 3)
- EXCESSIVE WEIGHT HAZARD
- To avoid
back or other injury, have more than one person move or lift
the dryer.
Using two or more persons, slightly tip the dryer back and lift it
onto the pedestal. Still tipped, slide the dryer back against the
rear brackets so tabs on rear brackets engage the slots on the
back of the dryer. Gently set down the front so the appliance is
between the front and rear brackets.
ENGAGE REAR TABS
TIP DOWN
2.
3.
@
m
-4
m
m
-4
®
m
-4
m
m
-4
@
m
-4
m
X
m
-4
®
Adjust the appliance side-to-side to align its mounting holes with
the pedestal's bracket holes.
Install a screw through the inner hole of each front bracket into
:_
the base of the dryer.
-4
ITI
4. Reinstall the plastic hole plugs in front panel.
m
-4
@
I
m
-4
m
Es) Installing
or re-installing
dryer (style 3)
1. Slide appliance/pedestal into place.
2. Check for levelness and rock all four (4)legs again. Repeat until
-4
level and solid.
3. Refer to Dryer Installation
Instructions for complete details on
installing electrical, gas, or exhaust venting.
@
I
m
-4
m
m
-4
@
Advertisement
