Frigidaire LGUB2642LP9 Use & Care Manual page 6

Leveling Freezer Drawer (if necessary)
To level the freezer drawer:
1. Check gasket seal around top, bottom, and sides of freezer drawer.
2. If gasket is not sealed, open drawer and slightly loosen four (4) drawer screws (two (2)
on each side) to allow drawer to rotate.
3.
Remove Hex
Head Drawer
Do Not Remove i
Other ScrewsJ
Screw
Close drawer and recheck the seal
on the gasket (A). Open the drawer
grabbing by the sides in the center (B).
Be careful not to rotate the drawer.
4.
5. Recheck gasket seal.
Tighten four (4) drawer screws.
Do Not Remove
Other Screws
Push
Against
Freezer
Drawer
Level Refrigerator & Adjust Doors (if necessary)
Guidelines for final positioning of your refrigerator:
* All four corners of the cabinet must rest firmly on the floor.
Remove Hex
Head Drawer
Screw
_Remove Hex
Head Drawer
Screw
* The sides should tilt 1/4 inch (6 mm) from front to back (to ensure that doors close and seal
properly).
* Doors should align with each other and
be level.
Host of these conditions can be met by raising or lowering the
adjustable front rollers,
To level the cabinet using the
front rollers:
1.
Slightly open freezer drawer. Lift the toe
grille and gently pull forward
(see illustration).
Toe Grille Must
Fit in Slot On
Assembly _/
A_.W
$