Electrolux EI30BM5CHSA Use & Care Manual page 31

CL i G CARE 31
Disconnect the power cord before cleaning or leave the door open to deactivate
the oven during cleaning.
CHARCOAL FILTERS
Charcoal Filters, which are attached with Hood
Louver, are used for nonvented, recirculated instal-
lation. The filter should be changed every 6 to 12
months depending on use.
Disconnect power to the microwave oven at the
circuit breaker panel or by unplugging.
Remove three Houver Louver Screws.
,
2.
3.
4.
,
Push the upper tabs and pull the louver away
from the unit.
Remove the charcoal filters from hood louver and
replace new charcoal filters by piercing tabs into
the holes in charcoal filters.
Carefully push the louver back into place and
replace the screws removed at step 2.
Oven Light Cover
Figure 1
Hood Louver
nnside of Hood Louver
Upper Tab
MICROWAVE OVEN LIGHT
Remove the louver per instructions 1-3 above, if
used.
1. To replace an old krypton light bulb, first discon-
nect power to the microwave oven at the circuit
breaker panel or by unplugging.
2. Open oven light cover by carefully pulling up on
the front edge. See figure 1.
S. Remove an old light bulb and replace a new 40
watts krypton light bulb. DO NOT USE BULB
LARGER THAN 40 WATTS.
,
Close the Oven Light Cover by carefully push-
ing into place. Push the louver back into place
(engaging both the bottom and top tabs) and
replace three Houver Louver Screws.
LIGHT BULB
1. To replace an old krypton light bulb, first discon-
nect power to the microwave oven at the circuit
breaker panel or by unplugging.
2. To open Light Cover, remove the screw on the
light cover. (See Figure 3.)
3. Replace the old 40 watts krypton light bulb with
new one. DO NOT USE A BULB LARGER THAN
40 WATTS.
,
Close the Light Cover and secure with screw
removed at step 2.
BOTTOM VIEW
Light Butb (Front of microwave oven)
k
\
Figure S
I _'x
Light Cover Screw
(Rear of microwave oven)
Figure 2
CAUTION
Light Cover may become very hot. Do not touch
glass when light is on.