TO REMOVEBELT/CLEAN B RUSH:
Carefully lift the right end of the agitator assembly
and then lift the left end. Remove the brush
assembly.
Remove the belt from the motor drive shaft.
PersonalInjuryHazard
Be careful when removing blush assembly, the be#
tension Is high. Failure to do so could result In
personal Injury from brush assembly releasing
quickly and mapping away.
Remove any dirt or debris in the belt path area or in
the brush roller area.
Carefully remove the brush supports and washers to
check for string and hair build-up.
NOTE:
When you remove
the brush supports,
a small washer on
each end may
come off. DO NOT
lose these two
washers.
Remove any string or debris.
Replace the
washers and
brush supports.
See exploded
view for
correct
assembly.
Exploded View- Brush
Assembly
c_
14