Electrical Data(For 115V Model); Use Of Extension Cords; Electrical Safety - Goldstar LXA1210ACL Owner's Manual

Bectrical Data
Electrical Data(For 115V model)
Line Cord Plug Use Wall Receptacle Power Supply
Parallel
Standard 125V, 3-wire grounding
receptacle rated 15A, 125V AC
Use 15 AMP time
delay fuse or 15 AMP
circuit breaker.
USE OF EXTENSION CORDS
Because of potenti_ safety hazards, we strongly discourage the use of an extension cord. However, if you wish to
use an extension cord, use a CSA certified!UL-Hsted 3-wire (grounding) extension cord, rat_ 15A, 125V.
Electrical Data(For230/208V model)
Line Cord Plug Use Wall Receptacle Power Supply
Do not under an€
Jrcumstance,s cut
r remove the
rounding prong
rom the p_ug. )
supply cord with
3-prong grounding plug
_-q fDo not under any"
_ // circumstan_s cut
_//,,._ or remove the
_.._ [ grounding prong
"-_J E from the pUug
Power supply cord with
3-prong grounding plug
Tandem
Standard 250V, 3-wire grounding
receptacle rated 15A, 250V AC
Standard 250V, 3-wire grounding
receptacle rated 20A, 250V AC
Use 15 AMP
time delay fuse or
circuit breaker.
Use 20 AMP
time delay fuse or
circuit breaker.
Refer to the nameplate
for correct fusing.
All wiring should be made in accordance with local electrical codes and regulations.
NOTE • Aluminum house wiring may pose sp_ial problems. Consult a qualified electrician.
[] ELECTRICAL SAFETY
IMPORTANT GROUNDING INSTRUCTIONS
Air conditioner has a three-prong grounding plug
on its power supply cord, which must be plugged
into properly grounded three-prong wall
receptacle for your protection against possible
shock h_ard.
FUSE - Use a time-delay fuse or circuit breaker.
Refer to the nameplate for proper power supply
requirements.
208, 230, and 208/230 VOLT UNITS
These units are equipped with a three-prong
grounding plug on the power supply cord, which
must be plugged into a matching properly
grounded three-prong wall receptacle for your
protection against possible shock h_ard. If such
an outlet is not present, one must be installled by a
qualified electrician in accordance with the National
Electrical Code and local codes and ordinances.
NOTE: DO NOT USE AN EXTENSION CORD
ON 20& 230, AND 208/230 VOLT UNITS.