Dyson DC07 Owner's Manual page 8

&t
u
o
o
o
o
o
Where to look for
blockages
,/_ CAUTION
, Disconnect the machine from
the electrical outlet before
starting to look for blockages.
Failure to do so could result
in electric shock or personal
iniury.
Please note: Should any part of
the machine become blocked,
the motor may overheat and stop
due to the thermal cut-off being
triggered. Disconnect from
dectricaJ outlet and Jet the
machine cool down for at least
30 minutes before dearing the
blockage.
Tools
Check that the tools are clear of
blockages.
Si i_ _
Wand
Press the wand release button to
remove the wand from the hose.
Check inside wand for blockages.
CAUTION
" Beware of sharp obiects
when clearing blockages.
di!i:i i i ' i:i:i ¸(::i ¸
Hose
Press the cyclone release catch
to remove the clear bin
assembly from the machine.
Press the hose release button
from the front of machine and
slide the hose out from the
rear, holding the lower cord
winder. Check inside the hose
for blockages.
U-bend oirwoy inspection
, Tilt the machine forward to
slide out the U-bend airway
inspection.
" Check inside for blockages.
_ii:_k_ _ '_f;!
:!_ i :ii/ill
Airway inspection volve
" Squeeze the valve release
catches to remove the airway
inspection valve.
" Check inside for blockages.
/'_ CAUTION
, The ratchet noise warns that
the brushbar is obstructed.
Disconnect the machine from
the electrical outlet before
removing the obstruction.
(:i! :
_i f ill
Brushbor
Lay the machine on its front.
Undo the colored soleplate
fasteners using a coin and
remove the solepJate.
2 Clear the brushbar
obstruction, carefully cutting
away any threads with a pair
of scissors.
Replace the soJepJate and tighten
the fasteners.
,/_ CAUTION
" Make sure all parts have
been replaced securely
before using your machine.
1#
©
o
o
B_
o