Cool Mode; Fan Mode - GE ADQ12 Owner's Manual And Installation Instructions

GEAppliances.com
Lights next to the touch pads on the air conditioner
control panel indicate the selected settings.
COOLMode
Use the COOL Inode with HIGH (F3), MED (F2) or
LOW(F1)
tim for
cooling.
Use the INCREASEA
/
DECREASE •
pads to set
the desired
temperature
between 60°F and 86°F in 1°F increments.
M_ electronic them/ostat is used to maintain tile
room temperatm'e. Tile compressor will cycle on
and off to kee I) tile room at tile set level of comflwt.
Set the them_ostat at a lower nttmber and the indoor
air will becolne coole_: Set tile fl/ern/ostnt at a higher
nmnber and tile indoor air will become wam_e_:
NOTE: ff theair conditioner i soff andis thenturnedon
whileset to COOL, i t will takeapproxl_nate/y 3 minutes
forthecompressor tostartandcoolingtobegin.
CoolingDescriptions
ForNormal Cooling--Selectthe COOL mode and
HIGH(F3)or MED (F2)fim with a middle set
temperature.
ForMaximum
Cooling--Select the COOL mode
and HIGH(F3)fire with a lower set temperature.
ForQuieter& NighttimeCooling--Selectthe
COOL mode and LOW (F/)fire with a middle set
temperature.
NOTE"/fyouswitchfroma COOL settingto OFF or toa fan
setting wait at least3 minutesbeforeswitching backtoa
COOL setting
FAN Mode
Use tile
FANat HIGH (F3),MED(F2)or LOW (F/)
to Since tim only settings do not provide cooling,
provide air circulation and filtering without cooling, a temperatm'e setting will not be displayed.
Power Outage Recovery Feature
In tile case el a power outage or interruption, tile
refit will automatically re-start in the settings last
used after tile power is restored.
Tile TlMERfeature
will reset to tile original setting. You may need to set
a new time if desired.
Vent Control
Tile vent control is located above tile control
panels.
When
set at CLOSE, only
tile air inside tile
room
will be circulated and conditioned, _Vhen set at
OPEN,
s ome inside air is exhausted outside.
To open the vent, pull the lever toward you.
To close it, push it hT.
Air Direction--Side-to-Side
Tile side-to-side air direction is a(!i usted
by moving
tile lever to tile left or right.
Air Direction--Up and Down
Fingertip pressure on tile horizontal lou\'e_
a(!iusts tile air direction
u I) or down.
(on some models)
5