Philips 8FF3WMI Firmware Upgrade Instructions

PhotoFrame Firmware Upgrade Instructions
Applicable models
Firmware version
Release date
Release notes

Important notice before updating

!
The firmware upgrade process will remove all photos currently stored on PhotoFrame.
Please make sure all photos on PhotoFrame are properly backed up before updating.
Please follow the steps below to upgrade the PhotoFrame firmware.
1 Format SD (Secure Digital) card
2 Copy all files from the 'Firmware' folder into the root folder of the SD card
(The root folder is the 'highest' folder in hierarchy, for example F:\)
3 Make sure PhotoFrame is powered Off
4 Insert SD into PhotoFrame with the new firmware into the PhotoFrame
5 Push the Power button to power on the PhotoFrame
6 The firmware upgrade will start automatically
Warning: Upgrade takes about 1 minute.
!
During the upgrade do not disconnect power, remove the memory or make new
connections. Otherwise this may harm your PhotoFrame.
7 When "Please reboot
8 Remove the memory from the PhotoFrame
9 Power Off the PhotoFrame and Power On afterwards by pushing the Power button
10 The upgrade has completed
You can check the new firmware version via
8FF3WMI
1.01
September 19, 2008
system!" shows, firmware upgrade has finished
Setup Status
→ → Firmware.
!
!