Follow - GE GCG1500P Owner's Manual

Hide thumbs Also See for GCG1500P:
Table of Contents

Advertisement

Available languages

Available languages

Cabinet-front
mounting
A
A Mounting clip
C. Retaining bracket
B. Cabinet
D. Mounting screw
8.
Grasp sides of compactor drawer and place bottom of drawer
into tracks. Lift at the handle so drawer will go over drawer stops.
Close drawer. Check to see if drawer opens freelg. If the toe plate
rubs against floor, see "Adjusting the Toe Plate" for further
instructions.
Adjusting the Toe Plate
If the toe plate rubs the floor covering, the toe plate clearance mag
be changed as follows:
1. Mark on each side of the toe plate the amount of toe plate that
rubs the floor covering.
2. Remove the drawer from the unit. (See Step 3 in the "Unpacking"
section.)
3. Use a ruler and a pencil or chalk to draw a line between the
marks on each side of toe plate.
4. Use scissors or utilitg knife to cut toe plate along line.
5. Replace drawer. If toe plate still rubs floor covering, repeat steps
1-4.
Installing a Custom Panel
Dimensions
Use these dimension drawings to create a custom panel for use
without a trim kit. The panel should be a minimum of 1/2" (13 mm)
thick.
Installation
1. Remove the 2 rubber bumpers from the lower corners of the
inside drawer front. Set aside the bumpers and discard the
screws.
2.
Align the bottom of the custom panel with the bottom of the
exterior drawer front and rest the panel on the rest tab.
NOTE: The bottom of the custom panel should not extend below
the bottom rest tab at the lower center of the exterior drawer
front.
3.
4.
Secure the custom panel to the exterior drawer front bg using
four #8 x 1" wood screws from the inside drawer front.
Install the top 2 wood screws as shown.
Use the bottom 2 wood screws to also reinstall the 2 rubber
bumpers on each side of the lower inside drawer while
attaching to the custom panel.
Attach a 15" x 1/2" quarter-round filler along the top inside edge of
the drawer front using glue or screws.
A Custom panel
B. 15" x ½" quarter round
C. Drawer front
D. Four #8 x 1" wood screws placement
E. Rubber bumper (one on each side)
293/8 ''
(74.6 crn)
_.__
15" __.
(36.1 cm)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gcg1580pGcg1700pZcgs150pZcgp150p

Table of Contents