GE GWS03ADWASS Owner's Manual And Installation page 9

Reversing the Door. ge.com
Screw
Hinge cover__._
Plug Button _ Tt
To ,,n0e
'i
om Hinge
Leveling Leg
O Unplug the wine chiller.
Tape the door shut with masking tape to secure alignment.
Remove the top hinge cover by removing the screw.
Remove the 2 screws securing the top hinge to the frame.
Leon the wine chiller backward to access the bottom hinge.
Remove the 2 screws securing the bottom hinge assembly to the
frame.
NOTE: If you lay the unit on its bQck, be sure to let it stand upright for
at leQst 2 hours before connecting to the power source; this will reduce
the possibility of a malfunction in the cooling system.
Remove the Plug Button from the top left side of the door.
O Install the Plug Button into the hinge hole on the right side.
Press firmly to secure.
O If the hQndle hQs been installed, remove it and install it
on the opposite side. Refer to Door Hondle section for instructions.
O Hold the door securely in place and install the bottom hinge
on the opposite side.
Install the top hinge Qnd cover on the opposite side. Moke sure
the door is aligned with the cabinet before tightening the screws.
Remove the tape. Open and close the door to check alignment with
the cabinet. If necessQry, loosen the screws on the bottom hinge,
realign the door and retighten the screws.
Plug in the wine chiller.
NOTE: If you hod to lay the unit on its bQck, be sure to let it stand
upright for ot leQst 2 hours before connecting it to the power source;
this will reduce the possibility of a malfunction in the cooling system.
Set the temperature controls to the desired setting.