GE DMCD330 Owner's Manual page 3

g_com
PROPER INSTALLAtiON
This dryer must be properly instafled and located in accordance with the Installation Instructions
before it is used. If you did not receive an Installation Instructions sheet, you can receive one by
visiting ge.com, or by calling 800.GE.CARES (800.432.2737).
• Properly ground dryer to confimn with all
governing codes and ordinances. Follow details
in the Installation Instructions section.
• Install or store where it will not be exposed to
temperatures below fl'eezing or exposed to
the weather:
• Connect to a properly rated, protected and sized
power supi)ly circuit to avoid electrical overload.
• ]_.elnove all shaq) packing itelns and dispose oI
all shiI)ping materials i)ropedy.
• In flflfilling the specific needs _ff different
commercial installations, the pro'chaser of this
dryer may wish to locate the coin box and
controls in any _ff a nulnber of locations.
The responsibility fin" the proper pe_f0mmnce
of this work lies solely with the pm'chase_;
It should be done by properly trained and
qualified pe_som_el, and in accordance with
local code requirements.
• Any coin box or similar device added to
the (hTeI; either electrically or mechanically,
should be properly grotmded.
• Remove any accumulated time by manually
rotating timing cam in the coin box
cotmterclockwise tmfil switch shuts off. Apply
a slight additional cotmterclockwise l)ressure to
fimher seat drive. Make certain not to mrn cam
past switch shutoff position. Otherwise, one
increment of time will be gained. Switches are
offwhen the plastic switch actuating am/ (inner)
is down and all 3 switch buttons are depressed.
Exhaust/Ducting
_] This dD'er MUSTbe exhausted to the outside.
[_ ljse onl) dgid metal 4" diameter ductwork
inside the dI3er cabinet. Use Olfly iigid metal
or flexible metal 4" diameter ductwork fin.
exhausting to the outside. USE
OFPLASTIC OR
OTHER COMBUSTIBLE DUCTWORK CANCAUSE
A FIRE. P UNCTURED DUCTWORK CANCAUSE A
FIREIF IT COLLAPSES ORBECOMES OTHERWISE
RESTRICTED I N USEORDURINGINSTALLATION.
Follow details in the Installation Instructions section.
3