GE JGBP35WEV3WW Use And Care & Installation Manual page 46

BEFORE YOU CALL FOR SERVICE.,,
(continued)
PROBLEM
:OVEN :DOOR:i::
Acc_ENTALLY
"door" :APPEARS
THE DISPLAY
:' A ER"
NUMB
:FLASH IN THE
POSSIBLE CAUSE
• Press the CLEAR!OFF pad. Allow the oven to cool and then unlatch the door.
OVEN CONTROL SIGNALS :
,AraXg COOK
OR STOP TIME : :
RAINBOW EFFECT IN • This is normal. It is caused by the heat treatment applied to the oven window.
THE OVEN
:: : ?
• Serf-cleaning cycle has been selected but latch handle was not moved all the
way to the fight. Move the latch handle.
Latch handle was moved to the fight but a program other than self-cleaning
was selected. Move the latch handle to the fight only when setting the
self-cleaning cycle.
, If the time display flashed "F--and a number," you have a function error code.
If a function eixor Code appears during the self-c!eaning cycle, check the oven
door latch. The latch handle may have been moved, even if only slightly, from
the latched position. Make sure the latch is moved to the fight as far as it wilt
go. Press the CLEAR/OFF pad. Allow the oven to cool for one hour. Put the
oven back into operation.
• Disconnect all powe r to the range for 5 minutes and then reconnect power.
If the failure code repeats, then call for service.
° This is reminding you to enter a bake temperature (see the Baking section).
• Improper air/gas ratio in ove n. Adjust oven burner air shutter.
• An odor from the insulation around the oven liner is normal for the first few
times oven is used. This is temporary.
If you need more help...call, toll free:
GE Answer Center ®
800.626.2000
consumer information service
46