Installation Instructions; Location Of Your Washer; Rough-In Dimensions - GE GFWH2400 Owner's Manual & Installation Instructions

Installation Instructions
LOCATION OF YOUR WASHER
Do Not Install the Washer:
1. In an area exposed to dripping water or outside
weather conditions. The ambient temperature should
never be below 60°F (!5.6°C) for proper washer
operation.
2. In an area where it will come in contact with curtains
or drapes.
S.On carpet. The floor MUST be a hard surface with
a maximum slope of 1/2" per foot (1.27 cm per
30 cm). To make sure the washer does not vibrate
or move, you may have to reinforce the floor.
NOTE: If floor is in poor condition, use 3/4" impregnated
plywood sheet solidly attached to the existing floor
covering.
IMPORTANT:
Minimum Installation Clearances
. When installed in alcove: Sides, Rear,
Top = O" (0 cm)
. When installed in closet: Sides, Rear,
Top = O" (0 cm), Front = 1" (2.54 cm)
. Closet door ventilation openings required:
2 louvers each 60 square in. (387 cm2),located 3"
(7.6 cm) from top and bottom of door
ROUGH-IN DIMENSIONS
FRONT
2 7"(68.58cm)
i 0 ® __ ====,_
s
_o
SIDE
34" {86.36 cm)
Y-x Y-x
*NOTE:
With Washer Legs: 40.5" (102.5 cm)
(0.75" adjustabiNtg)
With Pedestal: 53.75" (136.6 cm)
(0.75" adjustabiNtg)
Stacked: 82.75" (209.8 cm)
co
d
m cq
15