GE Profile Advantium SCB1000 Owner's Manual page 33

Troubleshooting
Advat_tium Ovet_
Questions?
Use this
prob#m
SO[?)eT
Problem Possible Causes What To Do/Explanation
LIGHTS
Light during a This is normal. * This is normal. The oven senses tile
speedcook cycle Power lexel has been heat level and adjusts automatically.
dims and cycles on automatically reduced
and off, even at full because the oven is hot.
power levels
Light visible around This is normal. * When the oven is on, light may
the door and outer be xisible around the door and
case while outer case.
speedcooldng
£4N
Fan continues to run The oven is cooling. * The fan will automatically shut off
after cooking stops when the internal parts of the oven
haxe cooled.
Oven vent emits warm This is normal.
air while oven is on
Fan comes on This is normal.
automatically when
using the microwave
COOKING
The oven makes Clicks and fhns blowing * These sounds are normal.
unusual sounds are normal. The relay
while cooking board is turning the
components on and of Ii
Smoke comes out Food is high in fat • Smoke is normal when cooking
of the oven when content. Aerosol spray high-fat fbods.
I open the door used on the pans.
Food is not fully Programmed times • Increase or decrease time for
cooked or browned may not match the size doneness or adjust the upper or
at the end of a or £m_ount of fbod you lower lamps for browning and
cooking program are cooking, doneness.
SENSOR ERROR
displayed along with
an oven signal
Food amount or type
placed in the o_en does
not match the program
that was set.
* Press the CLEAR/OFF pad. Set the
oven program to match the fbod or
liquid to be cooked or heated.
S/earn was not sensed by
the oven because plasti(
wrap was not xenmd, a lid
too tight was on the dish
or a liquid was covered.
• Vent plastic wrap, use a looser lid
or uncover liquids when cooking or
heating.