GE GBS18SBPARSS Owner's Manual And Installation Instructions page 19

Installation Instructions
[] TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT (For
freezer swing door models only)
Pull the base grille straight out to gain access to the
hinge bracket scre_vs.
Using a 5/] 6" socket wrench, remove the hinge
bracket, scrmvs, plastic washer and spacer shim from
the bottom right side of the cabinet.
Reinstall the spacer shim, hinge bracket, scrmvs and
plastic _:_sher to the bottom lett side of the cabinet.
Remove the cap fl'om the heft end of the base grille.
Install the cap, supplied inside the kit, on the right
end ot the base grille. Reinstall the base grille and
push it firefly into place.
[] TRANSFER CENTER HINGE
BRACKET TO THE LEFT
Remove the center hinge bracket and shim by
removing the three screws. NOTE: Keep these screws
with the hinge bracket. They are longer screws and will
be used when installing the hinge on the other side.
y
Remove the three painmd screws and take _:_she_
ti'om the center lett side of the cabinet. Screw them
into the holes on the right side, which were tmcovered
above.
Place the center hinge bracket and shim over the holes
at the center left side of the cabinet, Insert the three
screws that were removed with the center hinge bracket
at the begimfing of Step 4 and tighten secm'ely:
Do not install the him,e_ pin yet.
[] TRANSFER TOP HINGE
TO THE LEFT
Interchange hinge and shim at top right with two
plug buttons at top left of cabinet. Do not tighten
screws on hinge side at this time.
19