Advertisement
Adjust the rubber stand-off bumpers by turning them either in or out to adjust the tilt of the speaker until the front is vertical. Lock the adjusting
screws in place by tightening the locking nuts against the rear of the cabinet. Please be certain that the nylon washer is between the nut and
the cabinet to protect the cabinet finish.
Step 6
Since the TEATRO sound bar speakers form
the front 3 speakers in a home theater
system for flat panel displays they are to be
used and set up as you would any normal 5.1
to 7.2 surround sound system for balance
and level adjustments. The amplifier should
be set to the small speaker mode for the
left/center/right front speakers for the best
performance. The subwoofer setting should
be set to 80 Hz. We recommend the use of
our Phase Technology subwoofers and
surround speakers for complimenting your
installation.
Step 7
The EVT™ switch which is located on the
front of the speaker under the grille activates
Phase Technology's Enhanced Voice
Technology feature. This feature is designed to improve the clarity of the voice or dialogue from the center channel speakers in the system.
Flipping the switch to the "UP position engages the circuit and "DOWN" turns it off.
MOUNTING TO FLAT PANEL MOUNTING BRACKETS
There are additional mounting inserts on the rear of the speaker cabinet to facilitate attaching the sound bar
speakers to on wall flat panel mounts, see note figure 1. There are 6 threaded inserts provided that coincide with
the requirements of most manufactures mounts. Please check with your mount manufacture for applications and
compatibility.
MODEL
TWEETER
MIDRANGE
WOOFER
FREQUENCY
SENSITIVITY
IMPEDANCE
MAXIMUM POWER
DIMENSIONS
FINISH
WEIGHT
TEATRO SOUND BAR SPEAKER SPECIFICATIONS
1" SOFT DOME x 3
SATIN BLACK
WALL MOUNTING BRACKET
SPEAKER MOUNTING BRACKET
LOCKING SCREWS IN
SPEAKER BRACKET
T-V3.0
-----
5.25" VDT x 3
55Hz-22kHz
91 dB
4 OHMS
120 WATTS
40" (W) x 7" (H) x 4 ½" (D) (5 ½" with bracket)
25 LBS
FIGURE 3
LEVELING ADJUSTMENT
SCREW IN WALL BRACKET
T-PC3.0
1" SOFT DOME x 3
1.5" SOFT DOME x 3
5.25" RPF x 3
52hz-22kHz
89 dB
4 OHMS
150 WATTS
GLOSS BLACK
30 LBS
218-2082
Advertisement
