Advertisement
Advertisement
Table of Contents
Related Manuals for Event electronics S100
Summary of Contents for Event electronics S100
- Page 1 USER GUIDE...
- Page 2 • LFE channel monitoring (5.1 setup). Feed the LFE signal from your preamplifier or mixer into the S100’s Line In Mono input jack and set the S100’s level using the Input Sensitivity control. • Extending the low frequency response of your active monitoring system (2.1 setup).
-
Page 3: Care And Maintenance
5. Before calling, however, we ask that you please consult the Technical Support section of our Web site: www.event1.com If you believe that your S100 Active Low Frequency Monitor is in need of repair, please contact the Event Electronics Customer Service department to request a Return Authorization Number (RA#). - Page 4 S100 Active Low Frequency Monitor Specifications Low Frequency Driver 8” polypropylene cone with damped rubber surround and high-temperature voice coil. Frequency Response 35Hz – 120Hz, -3dB Amplifier Power 100W, Linear LFE Crossover 120Hz, 2nd-order Noise >70dB below full output Inputs Mono line input with 1/4”...
- Page 5 Santa Barbara, CA 93140-4189 www.event1.com Event Electronics® is a registered trademark of Event Electronics, LLC. S100 is a trademarks of Event Electronics, LLC. All rights reserved. No portion of this manual may be reprinted without written permission of Event Electronics.
Need help?
Do you have a question about the S100 and is the answer not in the manual?
Questions and answers