Summary of Contents for Patriot 1.0m Back Pack Antenna System
- Page 1 704 North Clark Street Albion MI 49224 USA Phone +1 517 629 5990 Fax +1 517 629 5990 www.sepatriot.com Patriot Antenna Systems Assembly Manual for the 1.0m Back Pack Antenna System 1.0 meter Back Pack Antenna Revision 002...
-
Page 2: Table Of Contents
CONTENTS INTRODUCTION ............................2 MECHANICAL SYSTEM DESCRIPTION ....................3 BACK PACK ............................. 3 AZ-EL ANTENNA BASE ......................... 3 1.0M REFLECTOR............................ 3 ..................................3 REFLECTOR ASSEMBLY ........................6 FEED ASSEMBLY ............................ 11 INTRODUCTION This is a deployable antenna system that comes carefully packed in a portable back pack case . -
Page 3: Mechanical System Description
MECHANICAL SYSTEM DESCRIPTION BACK PACK The antenna is provided in a carrying case measuring approximately 15 x 25 x 12”, and weighs approximately 65 pounds. The back pack case has the added features of having roller wheels and an extendable handle for easy handling where applicable. Back Pack shoulder straps are also provided for carrying the case on one’s back. - Page 5 MOUNT ASSEMBLY The pack has two divided compartments. The topmost compartment has an access flap that is easily opened with its’ perimeter zipper. Open this flap and you will find the Mount Assembly parts needed for this stage of the assembly. 1.
-
Page 6: Reflector Assembly
REFLECTOR ASSEMBLY Two of the reflector panels are in the topmost compartment, and the remaining four as well as the feed support parts are in the bottom compartment which can be accessed with the perimeter zipper around the middle of the case. Remove them taking note how they were packed so they can be repacked accordingly. - Page 7 3. Install panel T2 by simply guiding it into position as shown onto the alignment dowels. The panel will stay in place. The seam between the panels should look flush.
- Page 8 4. Install panel T1 and B3 using the same procedure as in step 3.
- Page 9 5. Install panel B1 and B3 using the same procedure as in step 3. Panels B1 and B3 will need to be held slightly back and aligned simultaneously with their respective upper panel and it’s alignment dowel.
- Page 10 After making sure all seams look flush fasten the two latches on the back of the dish, then fasten the six remaining perimeter latches.
-
Page 11: Feed Assembly
FEED ASSEMBLY 1. With all latches securely latched readjust Elevation Angle to facilitate attachment of the Feed Assembly parts. (Appox. 45deg) 2. Insert the Feed Tube assembly into the receiver at the bottom of panel B2. It must be held at the approximate angle shown. Then once it is fully inserted, rotate upwards to be able to attach the side struts. - Page 12 3. Attach each side strut. Snap on to side panels first then snap to corresponding ball snap on the Feed Tube assembly. Assembly is now complete. Antenna system can acquire satellite once RF connections are complete.