Sd/Mmc Card Installation; Turning The Unit On/Off - Sharp WA-TR30BK Operation Manual

SD/MMC card installation

WA-TR30(BK)/(W)
WA-TR300(BK)/(W)
ENGLISH
SD/MMC card installation
1. Open the battery cover.
2. Insert the SD or MMC card.
3. Close the battery cover.
Notes:
● SHARP will not be held liable for the loss of data whilst the SD/
MMC memory device is connected to the audio system.
● Files compressed in MP3 and/or WMA format can be played
back when connected to the SD terminal.
● This SD/MMC memory's format support FAT 16 or FAT 32.
● SHARP cannot guarantee that all SD/MMC memory devices will
work on this audio system.
● The SD terminal in this unit is not intended for a PC connection
but is used for music streaming with a SD/MMC memory device.
● The larger the capacity of the SD/MMC storage device, the longer
it will take for the data to be read.
● SD/MMC card are not included.
● SD/MMC card cannot be operate if battery power is low.
■ Checking the remaining amount of battery level
The battery level is shown by the battery indicator during operation.
03
● When the battery level is very low, the battery indicator will flash.
Replace the alkaline battery with a new one.
● When the battery has run out completely "
appear. Then, the power will be disconnected automatically.
Notes:
● The battery indicator will not correctly display the remaining
capacity for approximately 10 seconds after the power has been
turned on.
● The number of bars shown in the battery indicator may increase
or decrease, depending on the operation being performed. This
is normal.
● The battery life and the operating time may be shortened by
usage conditions, long periods of disuse, etc.
E-6
Battery indicator
When the battery When the battery
level is high level is very low

Turning the unit on/off

■ To turn on the unit
Press the
■ To turn off the unit
In any mode
1. Hold down the
■ Volume control
Whilst play or stop mode, press
Volume (– or +) button to decrease or
increase the volume.
■ Volume auto set-in
● If you turn off and on the main unit with volume set to 18 or higher,
the volume will start at 18.
● If you turn the unit off then on again with the volume level set to
less than 17, it will turn on again at the level set.
■ Back to previous level/screen
Shut down..." will
Press Volume (+) button for return to previous level/screen.
/ button.
/ button for 3 seconds or more.
Continue Holding On
To Power Off
MIN ..........
Good Bye!
16
39 MAX