Troubleshooting Guide - Euro-Pro EP033 Use And Care Instructions

HOW TO OPERATE YOUR HAND VACUUM
1. Hold the hand vacuum firmly with your hand on the Handle (4).
2. Push the On/Off Power Switch (2) to "On" position.
3. Start vacuuming.
CAUTION:
The Hand Vacuum is a very powerful unit. Make sure
that you hold it firmly, otherwise it can slip out of your
hand and cause injury.
CHANGING & CLEANING THE DUST CUP FILTER
Warning: Always unplug from electrical outlet before opening the Dust Cup
(container) (10).
1. To open the Dust Cup (container) (10), push button (1) and pull out the Dust
Cup (container ) (10), (fig. 1).
2. Pull out the Dust Cup Filter (8), (fig. 2).
3. Empty the dust from the Dust Cup Filter (8).
4. Rinse the Dust Cup Filter (8) in cold water, and then wait until it dries up
before replacing it into the Dust Cup (container) (10).
5. Place the Dust Cup Filter (8) carefully into the Dust Cup (container) (10).
6. Attach the Dust Cup (container) (10) to the Hand Vacuum.
Fig. 1
CAUTION:
The suction hole (3) must be open, free of any obstructions
at all times. Otherwise, the motor will overheat and could
get damaged.
Fig. 2
4

TROUBLESHOOTING GUIDE

PROBLEM POSSIBLE REASON
1. Power cord not firmly
HAND VACUUM WILL plugged into outlet.
NOT OPERATE 2. No power in wall outlet.
3. Needs servicing.
HAND VACUUM WILL 1. Dust cup filter is full.
NOT PICK-UP OR 2. Unit clogged.
SUCTION POWER IS 3. Dust cup filter needs
WEAK cleaning.
1. Dust cup filter is full.
DUST ESCAPING 2. Dust cup filter is not
FROM HAND installed correctly.
VACUUM 3. Puncture/hole in dust cup
filter.
HAND VACUUM HOSE
1. Hose clogged.
OR BRUSHES WILL
2. Dust cup filter is full.
NOT PICK-UP
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker.
Replace fuse/reset
breaker.
Call 514-842-8691
1. Empty dust cup filter –
(see page 4).
2. Turn unit off and unplug
from wall outlet. Remove
dust cup filter and check
for object(s) in air duct
and remove.
3. Clean or replace dust cup
filter. (see page 4).
1. Empty dust cup filter.
2. Review dust cup filter
instructions. (see page 4)
3. Replace dust cup filter.
(see page 4)
1. Remove hose and/or
bushes. Remove
obstruction from hose.
2. Empty and clean dust cup
filter.
5