Craftsman 917.370540 Owner's Manual page 7

TO ASSEMBLE GRASS CATCHER
1. Putgrass catcherframeinto grass bagwith
rigid part of bag on the bottom. Make sure
the frame handle is outside of the bag top.
2. Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold
them in warm water for a few minutes. If
bag gets wet, let it dry before using.
Vinyl Frame
bindings opening
TO PREPARE BATTERY
NOTE: Your battery must be charged
before you can start your lawn mower.
1. Connect battery charger connector
(male) to harness connector (female).
2. Plug battery charger into 110 volt A.C.
outlet.
3. Leave battery charger connected for
24 hours before starting your engine
for the first time.
4. After charging, disconnect harness
connector (female) from battery char-
ger connector (male).
Connect your battery charger to charge
battery after each use.
IMPORTANT: The engine will not re-
charge your battery.
At the end of the mowing season the
battery should be charged for 48 hours to
_lotect the battery during winter storage.
CAUTION: Always disconnect the
engine connector (male) from the battery
connector (female) to prevent accidental
starting when transporting or storing your
lawn mower after the season.
Battery charger Battery
box
Charger
Harness connector
connector (male)
(female)
Engine connector (male)
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be
used as a mulcher. To convert to bagging or
discharging, see "TO CONVERT MOWER"
in the Operation section of this manual.
7