GE Monogram ZIFI240 Owner's Manual page 14

Built-In Dimensions/Installation
th'_,sh-t_)md I¢_!/rigeralor
The flesh-food reflJg_rator is t_actolT set for
a l 10 ° door swing.
When in.stalled in a corner:
Check tile model number and allow tile
appropriam clearance for tile 90 ° door swing
and to allow racks to slide ont.
• ZIFS240 - 4" ndnimum to wall.
• ZIFI240 - 4-1/2" mininmn_ to wall.
Check tile model number and allow tile
appropriam clearance for tile 110 ° door
swlng.
• ZIFS240 - 14" minimum m wall.
• ZIFI240 - 16" minimum to wall.
NOTE: Clearances are based on the
recommended 2-1/4" handle standoff
depth. Ctlsmm handle clearances may vary
depending on the standoff of the custom
handle.
Choose the location:
• These products m W be closed in on tile
m I) and tilree sides as long as the fiont is
unobsuucmd for air circulation and
proper access to tile doon
14"Minimum ,
to Wall
(with CustomPanel
16"Min.)
h
,110° Door !
Swine
\
',,
,\
110° .,,, ',,, " ,,,
90° DoorSwing
90°
"" ......... 4P'I
21-5/8"
23-5/8"
4" Minimum
to Wall
(with CustomPanel
4-1/2" Min.)
• Do not install tilese products where the
temperature will go below 55°F (13°(;)
or aboxe 90°F (32°(;).
• Do not install where it will be subject to
direct sunlight, heat or moisture.
Black or Stainless Steel Toekick Options
Your CtlStOm panel (Zlf'I240 model only)
flesl>food reflig>rator is shipped witii
tWo
toekicks, a stainless steel and a black toekick.
For shipping purposes, one of tile toekicks
will be secured to tile back of tile unit and
the second will be installed on tile unit. Kee I)
tile unused toekick and other unused or
remox_d parts for possible flmue use.
Installing
custom 3/4"
door panel
and handh?
(ZIF[240 model
14
3/4" Overlay Panel Dimensions
Model ZIFI240 requires a field-installed
oxerlay door panel.
• Tile oveday panel nmst be secured to a
1/4" tilick backer panel that slides into tile
Uim. A.I 0" thick spacer panel must be
placed between tile ox>rl W and backer
panel.
• A custom handle of your choice, supplied
by your cal)inet make_; must be installed
on this overlay panel. Counmrsink all
screws into tile backer panel. Screws
cannot protrude flom tile backer panel.
NOTE: Maximmn total weight for cnstonl
door panel is 25 pounds.
1/4" Backer 9' ', .... _3-a/1{) 294)/16"
0.10" Spac_ r 22q/2" 2%1/16"
3/4" Or(flay 23-5/8 ...... a0
Overlay
Panel
Door
1/4"
Backer _ L.IO Inch
Panel Spacer