Advertisement
The following items for the operation of your chain saw are available at your nearest Sears store.-
,
Safety goggles
•
Air filter
•
Hearing protection
•
Fuel Stabilizer
•
Gloves
*
Spark plug
•
2-Cycle air cooled engine oil
•
Gas can
KNOW YOUR CHAIN SAW
Read this Operator's Manual and Safety Instructions before operating your chain saw. Compare the illustration below
(Figure 4) with your chain saw to familiarize yourself with the location of various controls and adjustments. Save this
manual for future reference.
1. Spark Plug
2. Air Filter
3. Primer
4. Choke Lever
5. On-Off Switch
6. Safety Lever
7. Throttle Lever
8. Fuel-Oil Mix Cap
9, Cover Over Pre-Filter
10. Bar-Chain Oil Cap
11. Bar
12. Chain
13. Bar Nuts
14. Half Throttle Pin (Pg. 6)
15. Side Cover
16. Top Cover
17. Lever- Handguard (Pg. 4)
18. Bucking Spike
19. Chain Tensioning Screw
20. Chain Tensioning Lug
21. Clutch Drum
22. Chain Brake Band
23. Oil Adjustment Screw
24. Sprocket
25. Serial Number
FIGURE 4
_,[o]l,_?j do] [1_I= i'Lo]ll;7 [_
_?:lvlvA
GASOLINE
AND
OIL MIXTURE
Importantl
Do not use automotive or boat oils in your
chain saw. These oils do not have proper additives for
2-cycle, air-cooled engines and can cause engine
damage.
The 2-cycle engine on this product requires a fuel
mixture of regular unleaded gasoline and a high quality
2-cycle air-cooled engine oil for lubrication of the
bearings and other moving pads. The correct fuel- oil
mixture is 40:1 (see Fuel Mixture Chart). Too little oil
or the incorrect oil type will cause poor performance
and may cause the engine to overheat and seize.
Gasoline and oil must be premixed in a clean
approved fuel container. Always use fresh regular
unleaded gasoline. This engine is codified to operate
on unleaded gasoline.
5
Advertisement
