Rgure 4 - Attseh Leg"B' t o Auembiy
•
Set assemblyadde,
•
Asserrble taltstockside leg set in
thesalnemanner as above,
ATTACHING LONG BRACES TO
LEG SETS
•
Place leg sets on floor upside down
apprcz, dmately 40" apart as shown in
Figure 5.
Rgure S- PositionLegAssemblies
,,
Positionlong brace inside the legs
and attach as indicated in Figure 6
usingfourbolts, washers and nuts.
Note that flange is locatedtoward
the top.
• Turnatandrights'tde up _¢_d posit'K_
at desired worklocation,
MOUNT WOOD LATHE
CAUTION; The wood lathe weighs
175 Ibs,Two people will be required to
set lathe on stand.
•
Carefully set lathe on stand. Align
holes in lathe bed to slots in top of
stand as shown in Figure 7. Attach
lathe to stand usingtour 8-1.25 x
35mm has head bolts,eight 8mm
flat washers, four 8ram _
washers
trod(_J_ 8rrcn he_ nuts. Oo not
tighten fasteners _mpletely,
F_m'_ 7 - Mounting_tots _ Lsthe
Make sure stand sets fiat on floor.
Adjust legs i' needed.Tighten all
stand [astenarssecurely,
•
Securely tighten lathe mountingfaS-
teners,
ATTACH TOOL HOLDER
• Attach tool holder to right front leg
usingthree 4-0.7 x 12ram pan head
screws,4ram flat washers and 4rnm
he=(nuts.
Figure 6 - AtJach I.on
•
Attech remaining long brace in the
Sa_
manner as abcv_