Advertisement
3
IMPORTANT!! PLEASE READ ENTIRE
INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE
KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT
Step 1: Remove all protective materials and set parts on a flat, non-abrasive surface. Identify parts
packed in carton against the parts list. If you are missing any parts or are unsure as how to
proceed with the assembly, Please call our Customer Service Center at 1-800-416-3511.
Do not attempt assembly if any parts are missing or damaged.
Step 2: Place the natural stone table top upside down on a flat, non-abrasive surface. Insert four
1/4"x35 mm headless bolts into the pre-drilled hole on the underside of the natural stone
tabletop as shown in Fig. 1 Do not over tighten.
Step 3: Attach a leg to the connector bracket. Add Ø6.5x1.0 mm washers and spring washers to
1/4"x35 mm bolts and carefully guide the bolts through leg connector bracker and into the
pre-drilled holes in the table leg (each leg uses four bolts--two on each side) as shown in
Fig. 2. Do not over tighten. Repeat on remaining leg.
Step 4: Attach "L" metal bracket to top base using two 1/4"x18 mm bolts and spring washers and
Ø6.5x1.0mm washers as shown in Fig. 3. Guide bolts through holes in "L" metal bracket
and into pre-drilled holes in the top base. Do not over tighten. Repeat for remain "L" metal
brackets.
4
Advertisement
