Table of Contents
Advertisement
TO ASSEMBLE
GRASS CATCHER
• Put grass catcher frame into grass bag
with rigid part of bag on the bottom.
Make sure the frame handle is outside
of the bag top.
• Slip vinyl bindings over frame.
NOTE:
tf vinyl bindings are too stiff, hold
them in warm water for a few minutes.
If
bag gets wet, let it dry before using.
_CAUTION:
Do not run your lawn mower
without clipping deflector or approved
grass catcher in place.
Never attempt to
operate the lawn mower with the rear
door removed or propped open.
Catcher
frame _-_
-_
handle
ENGINE
CARBURETOR
Your carburetor has a non-adjustable fixed
main jet for mixture control. If your engine
does not operate properly due to suspected
carburetor problems, take your lawn mower to
an authorized service center for repair or
adjustment.
IMPORTANT:
Never tamper with the engine
governor, which is factory set for proper
engine speed. Overspeeding the engine
above the factory high speed setting can be
dangerous, if you think the engine-govemed
high speed needs adjusting, contact your
nearest authorized service center, which has
proper equipment and experience to make
any necessary adjustments.
ENGINE SPEED
Your engine speed has been factory set. Do
not attempt to increase engine speed or it
may result in personal injury. If you believe
that the engine is running too fast or too slow,
take your lawn mower to an authorized
service center for repair and adjustment.
Immedmtely prepare your lawn mower for
storage at the end of the season or if the unit
will not be used for 30 days or more.
LAWNMOWlER
When lawn mower is to be stored for a period
of time, clean it thoroughly, remove all dirt,
grease, leaves, etc. Store in a clean, dry area.
• Clean entire lawn mower (See "CLEAN-
ING" in the Maintenance section of this
manual).
• Lubricate as shown in the Maintenance
section of this manual.
• Be sure that all nuts, belts, screws, and pins
are securely fastened. Inspect moving
_acefOr damage, breakage and wear.
if necessary.
• Touch up all rusted or chipped paint
surfaces; sand lightlybefore painting.
HANDLE
• You can fold your lawn mower handle
for storage.
• Loosen the two (2) handle knobs on
sides of the upper handle and allow
handle to fold down to the rear.
• Squeeze the bottom ends of lower
handle toward each other until pins in
handle clear the brackets and pivot
entire handle assembly forward and
allow it to rest on mower.
• When setting up your handle from the
storage position, the lower handle will
require manually locking into the
mowing position.
IMPORTANT:
When folding the handle for
storage or transportation, be sure to fold
the handle as shown or you may damage
the control cables.
14
Advertisement
Table of Contents
