Frigidaire FRA055XT710 Use & Care Manual page 8

Operating Instructions
(continued)
TO CHANGE TEMPERATURE DISPLAY:
temper#her
cool auto m
m energy sever hi
]a,_
o,ly Io
DO THIS:
PRESSAND HOLD
THE UP/DOWN
BUTTONS TOGETHER
FOR 3 SECONDS
YOU WILL SEE:
tamp/timer
cool auto m
m energysuver hf
Jan only lo
®
Note: The control is capable of displaying temperature
in degrees Fahrenheit or degrees Celsius.
FAULT CODES
f
tamp/timer
cool auto m
[] enetgysaver hi
danonly lo
0
\
ternp/bmer
cool auto m
[] energysaver hl
fan only
lo
®
ff the display reads "AS" or "ES",
a sensor has failed. Contact your
Authorized Frigidaire Service Center.
TO TURN UNIT OFF:
temp/timer
coo[ euto
enelgysc_ver hi
@r_ only lo
®
J
DO THIS:
I PRESS ON/
ADDITIONAL THINGS YOU SHOULD KNOW
Now that you have mastered the operating procedure, here are more features in your control that you should become familiar with.
Z_ • The "Cool" circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. ,/_
This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue
to run during this time.
• There is a 2-Second delay for the compressor shutting down when selecting FAN ONLY. This is to cover the possibility of having
to roll through to select another mode.
• The control will maintain the set temperature within 2 degrees Fahrenheit, between 60F and 90F degrees.
• After a power outage, the unit will memorize the last setting and return the unit to the same setting once power is restored.
AUGER WHEELS
Air Directional Louvers
Air directional louvers control air flow direction. Your air conditioner has the louver
type described below.
8
Auger Type
The louvers will allow you to direct the air flow Up or Down and Left or Right
(8-WAY) throughout the room as needed. Rotate the Auger Wheels until the desired
Left/Right direction is obtained. Pivot horizontal louvers until the desired
Up/Down direction is obtained.
@2009 Electrolux Home Products, Inc. All rights reserved.