Advertisement
REMOVING
COLLECTED
WATER
1. Emptying
the Bucket:
a. When the bucket is full the unit will shut down and the BUCKET
FULL
indicator
light will illuminate.
b. Do not move the unit at this point otherwise
water may spill on the floor.
c. Press sides of bucket gently to unclip the bucket from the unit.
d. Remove
the bucket as shown in the photographs
below and empty the
bucket.
k@ _@l
_ 7 _0_/'_ , .....
--_XR ,i"
/
/
e. Replace the empty bucket back into the unit and once seated correctly
the unit will start up again.
f.
You should hear a click when the bucket is in the correct position.
If the bucket full light does not extinguish,
check that the float is correctly
snapped
in place as indicated
by the diagram.
Advertisement
