Frigidaire GLGH1642DS1 Owner's Manual page 9

i
• Followthe guidelines below for preparing the load for drying.
• Readtile Dryer Operating Instructions for operating your specific model.
• Always read and follow fabric care labels and laundry product labels.
\
Follow fabric care label instructions.
_To reduce tile risk of fire, electrical shock, or injury to persons, read
tmportantSafetytnstructions, pages 2-3, before operating this dryer.
Prepare items for drying.
• Dry items of similar fabric, weight and construction in tile same load.
• Separate dark items from light-colored items. Separate items that shed lint
from those that attract lint. If an item sheds lint, turn it inside out.
• Besure buckles, buttons and trim are heatproof andwon't damagethedrum
finish. Close zippers, fasten hooks and Velcro®qike fasteners. Tie strings and
sashesto prevent tangling.
• If possible, turn pockets inside out for even drying.
• Check for stains which may not have been removed in washing. Dryer heat
may permanently set some stains. Repeat stain removal process before
drying.
• Placesmall items in a mesh bag to prevent tangling and for easy removal.
Place small items in a mesh bag.
.
3.
Check that lint screen is clean and in place.
Load the dryer.
• The average load will fillthe drum 1/3 to 1/2 full. Items need room totumble
freely for even drying and less wrinkling. Do not overload dryer.
• When drying large items, dry only2 or 3 at a time. Filloutthe load with small
and medium sized items.
For delicate or very small loads, add 2 lint-free towels for better drying, less
wrinkling, and to prevent grease stains caused by fabric softener sheets.
Do not overdry items. Overdrying can cause wrinkling, shrinkage, harshness,
and a build-up of static electricity, which can produce more lint.
If desired, add a dryer fabric softener sheet.
Fill dryer drum 113to 1/2 full,
.
5.
6.
7.
Close the dryer door and set dryer controls (some models).
See Dryer Operating Instructions for your specific model controls.
Turn cycle selector dockwise to the desired setting.
Start the dryer.
• PushStart Button for 2 seconds or turn the STARTknob clockwise to ON, hold
for I-2 seconds and release.
• To add or remove itemswhen the dryer is running, open the door. The dryer
will always stop when the door is opened. Allow the drum to come to a
complete stop before reaching inside.
• To restart dryer, close the door then push the Start Button for 2 seconds or
turn tile STARTknob clockwise to ON, hold for I-2 seconds and release.
• The dryer will not start if tile cycle selector is in the OFFposition.
When the cycle ends, remove items immediately and hang
of fold. If load is removed before tile cycle ends, turn cycle selector to OFF.