Stop Switch; Primer Bulb; Start Lever; Edge Guide - Craftsman WEEDWACKER C944.514460 Instruction Manual

25cc / 1.5 cu.in. 2-cycle 17 inch cutting path / 0.080 in. line gasoline weedwacker
Table of Contents

Advertisement

1.
Remove wing nut from shield.
2.
Insert bracket into slot as shown.
3.
Pivot shield until bolt passes
through hole in bracket.
4.
Securely tighten wing nut onto bolt.
Shield
PIVOT
Line Limiter
Blade
Slot
Bracket
Nut
KNOW YOUR TRIMMER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT Compare the illustrations with your unit to familiarize yourself with the location of
the various controls and adjustments. Save this manual for future reference.
Muffler
Shaft
Edge
Guide
Shield
Trimmer
_#
Head
Line Limiter
Blade
Spark Plug
Primer
Bulb
Throttle
Trigger
--
Start Lever
Fuel Mix File Cap
Starter Handle
STOP SWITCH
The STOP switch is used to stop the en-
gine. To stop the engine, push and hold
the switch in the STOP position until the
engine stops.
PRIMER BULB
The PRIMER BULB removes air from
the carburetor
and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate
the primer bulb
by pressing
it and allowing
it to return
to its original
form.
START LEVER
The START LEVER helps to supply fuel
to the engine to aid in starting. Acti-
vate the starting system by moving
the
start lever to the START position.
DO
NOT squeeze
the throttle trigger until
the engine has started and runs. After
the engine starts, allow the engine to
warm-up
10 seconds,
then fully
squeeze
the throttle trigger to deacti-
vate the starting system.
EDGE GUIDE
The EDGE GUIDE protects the unit from
contacting the ground during edging.
BEFORE STARTING ENGINE
_J'WARNING:
Besureto read
the fuel informationin the safety rules
before you begin. If you do not
understand the safety rules, do not
attempt to fuel yourunit. Contact your
Sears Service Centre.
FUELING
ENGINE
_J.WARNING:
Remove fuel cap
slowly when refueling,
This engine is certified
to operate on
unleaded
gasoline.
Before operation,
gasoline
must be mixed with a good
quality synthetic
2-cycle air-cooled
engine oil,
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents