ASSEMBLY
CONNECT
SHIFT ROD (See Fig. 6)
•
Insert end of shift rod farthest from bend into hole of
shift lever Indicator.
•
Insert hairpin clip through hole of shift rod to secure.
•
insert other end of shift rod Into hole in shift lever.
•
insert second hairpin clip through hole of shift rod°
REMOVE TILLER FROM CRATE
•
Make sure shift lever indicator is in "N" (neutral) posi-
tion (See Fig. 6)
•
Tilt tiller forward by liftinghandle_ Separate cardboard
cover from leveling shleld_
•
Rotate tiller handle to the right and pull tiller out of
carton.
ATTACH THIS END
TO SHIFT LEVER
INDICATOR
!
ATTACH THIS
END TO SHIFT
\
SHIFT' ROD
SHIFT
HAIRPIN
SHIFT
CUP
LEVER
INDICATOR
INSERT CABLE CLIP
(See Fig. 7)
•
Insert plastic cable clip into hole on the back of handle
column° Push cables into clip,
CABLES
"CABLE CLIP
FIG. 7
CHECK TIRE PRESSURE
The tires on your unit were ovednflated at the factory for
shipping purposes.
Correct and equal tire pressure is
important for best tilting performance.
•
Reduce tire pressure to 20 PSI.
HANDLE HEIGHT
•
Handle height may be adjusted to better suit operator°
(See "TO ADJUST HANDLE HEIGHT' in the Service
and Adjustments section of this manual).
FIG. 6
8