Advertisement
Available languages
Available languages
CHECK FOR DAMAGED OR
WORN PARTS
Contact Sears Service Center for re-
placement of damaged or worn parts.
NOTE: It is normal for a small amount
of oil to appear under the saw after en-
gine stops, Do not confuse this with a
leaking oil tank.
• ON/STOP Switch - Ensure ON/STOP
switch functions properly by moving
the switch to the STOP position.
Make sure engine stops; then restart
engine and continue.
• Fuel Tank - Do not use saw if fuel
tank shows signs of damage or
leaks,
• Oil Tank - Do not use saw if oil tank
shows signs of damage or leaks.
CHECK FOR LOOSE
FASTENERS AND PARTS
• Chain Brake Nuts
Chain
Muffler
Cylinder Shield
Air Filter
Handle Screws
Vibration Mounts
Starter Housing
Front Hand Guard
CHECK CHAIN TENSION
WARNING:
Wear protective
gloves when handling chain.
The
chain is sharp and can cut you even
when it is not moving,
Chain tension is very important,
Chains stretch during use. This is es-
pecially true during the first few times
you useyour saw, Always check
chain tension each time you use and
refuel your saw,
1, Use the screwdriver
end of the
chain adJustment tool (bar tool) to
move chain around guide bar to
ensure kinks do not exist. The
chain should rotate freely.
_
I
ChainAdjusbnont
v"_l" ,='_'"
Adjusting
Tool
u_s
Screw"
(Bar T_._I)
2, Loosen chain brake nuts until they
are finger tight against the chain
brake,
3, Turn adjusting screw clockwise un-
til chain solidly contacts bottom of
guide bar rail.
4. Using bar tool, roll chain around
gbuidebarto erasure all links are in
ar groove.
5. Lift up tip of guide bar to check for
sag. Release tip of guide bar, then
turn adjusting screw until sag does
not exist.
6. While lifting tip of guide bar, tighten
chain brake nuts securely with the
bar tool.
/ZL/) Ohm,,,
Br, A
/-.
I_F-_#"
Nuts
_
..,4:
7, Use the screwdriver end of timebar
tool to move chain around guide bar,
8, If chain does not rotate, it is too
tight, Slightly loosen chain brake
nuts and loosen chain by turning
the adjusting screw counterclock-
wise. Retighten chain brake nuts,
g, If chain istoo loose, it will sag be-
Iow the guide bar. DO NOT operate
the saw if the chain is loose.
Z_
41WARNING:
If the saw is operated
with a loose chain, the chain could
jump off the guide bar and result in se-
rious injury.
CHECK CHAIN SHARPNESS
A sharp chain makes wood chips, A
dull chain makes a sawdust powder
and cuts slowly. See CHAIN SHARP-
ENING in timeSERVICE AND ADJUST-
MENTS section.
CHECK GUIDE BAR
Conditions which require guide bar
maintenance:
• Saw cuts to one side or at an angle.
• Saw has to be forced through the cut,
• Inadequate supply of oil to barlchain.
Check the condition of guide bar each
time chain is sharpened. A worn guide
bar will damage the chain and make
cutting difficult.
14
Advertisement
