Craftsman WEEDWACKER 358.799160 Operator's Manual page 8

SWEEPING
The fanning action of the rotating line
carl be used for a quick and easy
clean up. Keep the line parallel to and
above the surfaces being swept and
move the tool from side to side.
CUSTOMER RESPONSIBILITIES
Sweeping
CARE & MAINTENANCE TASK I
Check for Loose fasteners and parts I
Check for damaged or worn parts
I
Clean unit and labels I
WHEN TO PERFORM
Before each use
Before each use
After each use
GENERAL RECOMMENDATIONS
The warranty on this unit does not cov-
er items that have been subjected to
operator abuse or negligence. To re-
ceive fult value from the warranty, the
operator must maintain unit as instruct-
ed in this manual. Various adjustments
will need to be made periodically to
properly maintain your unit.
CHECK FOR LOOSE
FASTENERS AND PARTS
= Housing Screws
• Assist Handle Screws
° Debris Shield
CHECK FOR DAMAGED OR
WORN PARTS
Refer replacement of damaged/worn
parts to your Sears Service Center.
o Trigger Switch - Ensure switch func-
tions properly by pressing and re-
leasing the trigger switch. Make sure
motor stops.
° Debris Shield - Discontinue use of
unit if debris shield is damaged_
CLEAN UNIT & LABELS
° Clean the unit using a damp cloth
with a mild detergent.
- Wipe off unit with a clean dry cloth.
REPLACING THE LINE
° Remove the spool by firmly pulling
on the tap button.
o Clean entire surface of hub and
spool.
o Replace with a pre-wound spool
(# 71-85837), or cut a length of 30
feet of .065" (1.6 ram) diameter
Craftsman® Pro Trimmer line. Use of
heavier lines could overload the unit
and damage unit. Never use wire,
rope, string, etc., which can break off
and become a dangerous missile.
8
• Insert one end of the line about 1/2
inch (1 cm) into the small hole inside
the spool.
o Wind the line evenly and tightly onto
the spool. Wind in the direction of the
arrow found on the spool.
• Push the line into the notch, leaving
3 to 5 inches (7 - 12 cm) unwound.
• Insert the line into the exit hole in the
hub as shown in the illustration.
• Align the notch with the line exit hole.