NuTone 9422P Specification Sheet

MODELS 9422P & 9427P
INFRARED
BULB HEATERS
Quick and efficient, these twin-bulb heaters provide
the selective temperature control you need.
FEATURES
•
White-white polymeric grille
•
Sturdy steel housing
•
Adjustable mounting brackets that span up to 24"
• Housing can be adjusted vertically after ceiling is finished
• Uses (2) 250W BR40-size infrared bulbs (not included)
• Bulbs may be operated separately or in combination
using the following controls:
Model 59W/V, 60-Minute Time Control
Model 61W/V, 15-Minute Time Control
Model 62W/V, 60-Minute Time Control with 2 Toggle
Switches (Model 9427P only)
Model 63W/V, 60-Minute Time Control w/Toggle Switch
Model 66W/V, Heat/Fan/Light Control (Model 9427P only)
Model 68W/V, Two-Function Control
•
Suitable for use in insulated ceilings (Type I.C.)
MODEL 9427P BULB HEATER/FAN ONLY:
• Plug-in, permanently lubricated motor
• Quiet, polymeric blower wheel
•
Polymeric damper/duct connector with 1-5/8" long tapered
sleeve and no metallic clatter
•
Unit may function with bulbs and fan controlled together,
bulbs and fan controlled separately, or EACH bulb and fan
controlled separately
SPECIFICATIONS
MODEL VOLTS AMPS WATTS*
9422P 120 4.3
9427P 120 4.5
* Total Connected Load
** BR40-size Infrared Bulbs. Use house wiring rated 60°C min.
HVI-2100 CERTIFIED RATINGS comply with new testing technologies
and procedures prescribed by the Home Ventilating Institute, for off-
the-shelf products, as they are available to consumers. Product
performance is rated at 0.1 in. static pressure, based on tests
conducted in AMCA's state-of-the-art test laboratory. Sones are a
measure of humanly-perceived loudness, based on laboratory
measurements.
NuTone, Inc., 4820 Red Bank Road, Cincinnati, OH 45227 (1-800-543-8687)
REFERENCE QTY.
SONES CFM DUCT
505** ---- ----
545** 3.5 70 4" Round
Product specifications subject to change without notice
REMARKS
SPECIFICATION SHEET
TYPICAL SPECIFICATION
Bulb heater shall be NuTone Model 9422P (NuTone Model
9427P).
Heater shall have corrosion resistant steel housing and
adjustable mounting brackets.
Unit must use (2) 250W BR40-size infrared bulbs. Bulb
Heater to be U.L. Listed. Suitable for use in insulated ceilings
(Type I.C.)
MODEL 9427P BULB HEATER/FAN ONLY:
Motor assembly to be removable and permanently lubricated.
Non-metallic damper/duct connector to be included.
Heater and ventilator to operate separately (or in combination).
Air delivery shall be no less than 70 CFM and sound level no
greater than 3.5 Sones. All air and sound ratings shall be
certified by HVI.
----
Project
Location
Architect
Engineer
Contractor
Submitted by
Model
9422P
Date
50G
Model
9427P
99042989E