To Start Engine; To Stop Engine; Add Gasoline - Craftsman 917.388800 Owner's Manual

5.5 horsepower 21" multi-cut rotary lawn mower
Table of Contents

Advertisement

Available languages

Available languages

• Check oil level before each use. Add
oil if needed.
Fill to full line on dipstick.
• Change the oil after every 25 hours of
operation or each season.
You may
need to change the oil more often
under dusty, dirty conditions.
ADD GASOLINE
• Fill fuel tank to bottom of tank filler
neck.
Do not overfill. Use fresh, clean,
re.gular unleaded
gasoline with a
mm_mum of 87 octane.
Do not mix oil
with gasoline.
Purchase fuel in
quantities that can be used within 30
_ldays
to assure fuel freshness.
CAUTION;
Wipe off any spilled oil or
fuel.
Do not store, spill or use gasoline
near an open flame.
A CAUTION:
Alcohol blended fuels
(called gasohol or using ethanol or
methanol) can attract moisture which
leads to separation
and formation
of
acids during storage.
Acidic gas can
damage the fuel system of an engine
while in storage.
To avoid engine
problems, the fuel system should be
emptied before storage of 30 days or
longer. Drain the gas tank, start the
engine and let it run until the fuel lines
and carburetor are empty. Use fresh fuel
next season.
See Storage instructions for
additional
information.
Never use engine
or carburetor cleaner products in the fuel
tank or permanent damage may occur.
Oil filler cap/dipstick
Upper limit
Lower limit
TO START
ENGINE
NOTE" Due to protective coatings on the
engine, a small amount of smoke may be
present during the initial use of the
product and should be considered
normal.
1. Turn fuel valve to ON position.
2. To start a cold engine, move handle
mounted throttle/choke
control lever to
CHOKE
position.
3.
Hold operator presence
control bar
down to the handle and pull starter
handle quickly. Do not allow starter
rope to snap back.
4. Slowly move throttle control lever to
FAST position after engine starts.
• To start a warm engine, move throttle
control lever to FAST position, then
follow steps above.
TO STOP
ENGINE
• To stop engine,
release operator
presence control bar. Wait until blade
and all moving parts have stopped and
turn fuel valve to OFF position if you do
not intend to restart the engine soon.
ON
Fuel valve lever
Gasoline
filler cap
Oil
cap
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents