Advertisement
engine a ndletitrununtil t hefuellines
andcarburetor areempty. Use fresh
fuelnext s eason.
Never useengine o rcarburetor clean-
erproducts inthefuel t ank orperma*
nent d amage may occur.
SeetheSTORAGE
section f oraddition-
alinformation.
HOW TOSTOP YOUR UNIT
• To stop theengine, move the
ON/OFF switch t otheOFF position.
• Ifengine d oes notstop, m ove choke
lever t oFULL C HOKE position.
FSwitch
HOW TO START YOUR UNIT
_Jb WARNING:
The trimmer head
will turn while starting the engine.
Avoid any contact with the muffler. A
hot muffler can cause serious burns.
STARTING A COLD ENGINE (or a
warm engine after running
out of
fuel)
Starting Position
Primer Bulb
Handle
Choke
.Lever
Muffler
1. Set unit on a flat surface.
2. Move ON/OFF switch to the ON
position.
3. Slowly press the primer bulb 6
times.
4. Move choke lever to FULL CHOKE
by aligning lever with position
shown on decal (see illustration
below).
Choke
position
decal
5. Squeeze the throttle trigger fully and
hold through all remaining steps.
6. Pull starter rope handle sharply
until engine sounds as if it is trying
to start, but do not pull rope more
than 6 times.
7. As soon as engine sounds as if it
is trying to start, move choke lever
to HALF CHOKE by aligning lever
with position shown on decal (see
following illustration).
Choke
position
8. Pull starter rope sharply until engine
runs, but no more than 6 pulls. If the
engine doesn't start after 6 pulls (at
the HALF CHOKE position), move the
choke lever to the FULL CHOKE
position and press the primer bulb 6
times. Squeeze and hold the throttle
trigger and pull the starter rope 2
more times. Move the choke lever
to the HALF CHOKE position and pull
the starter rope until the engine
runs, but no more than 6 pulls. If the
engine doesn't start, repeat proce-
dure 2 additional times.
NOTE: If engine still doesn't start, it
is probably flooded. Proceed to
STARTINGA FLOODED ENGINE.
9. Once the engine starts, allow it to
run 10 seconds, then move the
choke lever to OFF CHOKE by
aligning lever with position shown
on decal (see illustration below).
Allow the unit to run for 30 more
seconds at OFF CHOKE before re-
leasing the throttle trigger. NOTE:
If engine dies with the choke lever
in the OFF CHOKE position, move
the choke lever to the HALF
CHOKE position and pull the rope
until engine runs, but no more than
6 pulls.
10
Advertisement
