Advertisement
TO ASSEMBLE
AND ATTACH
GRASS
CATCHER
(See Figs.
3A thru
4)
•
Insert leg of tubular frame through front opening of
grass catcher and thread frame into sewn hem of bag
NOTE: Keep bag hem gathered on the straight leg of the
tubular frame
o
When frame comes out the other end of sewn hem,
immediatelywork the end of frame down inside the bag
as shown in inset.
°
Slide sewn hem evenly around the tubular frame until
both ends of frame are exposed out of the front open-
ing
o
Assemble iowerframe to tubular frame as shown Be
sure handle is outside of bag and frames are fully
seated as shown in inset
o
Slip vinyl bindings over frame
NOTE: If vinyl bindings are too sliff, hold them in warm
water for a few minutes. If bag gets wet, let it dr/before
using.
-
Close the flip lid. Flip lid must be closed while operating
lawn mower
;
Lift the rear door on the mower housing and place the
grass catcher frame onto the formed tabs on the rear
door hinge brackeL
o
The grass catcher is secured to the lawn mowe?
housing when'the rear door is Iowe_'edonto the grass
catcher frame
_
AUTION:
Do not run your lawn mower
without
clipping
deflector
or approved
grass
catcher
in place.
Never attempt
to operate
the lawn mower with the rear
door removed
or propped
open.
TUBULAR
FRAME
SEWN HEM
FLIP LID
"_--'_-
LOWER
-_ .__," _*
I
_
//
II
(Franiesmust
TUBULAR
///
k
_/
/
FRAME
//
"_-,,,_..,j"
FIG. 3B
LOWER
FRAME
HANDLE
\
FIG. 3C
REAR DOOR
GRASS
CATCHER
FRAME
FORMED
TABS
FIG: 4
FIG. 3A
7
Advertisement
