Advertisement
1.The trimmer comes i n2pcs.(Upper andLower S hafts), thatmust b econnected byhand.
The Safety G uard must beattached.
2. Remove theUpper andLower S hafts a ndSafety G uard from the carton and inspect
your t rimmer.
3. Donot d iscard b ox orpacking material until allparts areexamined.
z_ WARNING:
If any part of the trimmer
is missing or damaged, do not plug
in the trimmer
until the damaged
part is repaired or replaced.
1
Fig. 1
Auxiliary Handle
Upper Shaft
Trimmer
Head
Lower Shaft
\
Screws for attaching Safety Guard
Safety Guard
KNOW YOUR TRIMMER (Fig. 2, 2a, 2b and 3)
NOTE: Before attempting
to use this product, familiarize
yourself
with all
operating
features
and safety rules.
1
Your trimmer/edger
has a precision built electric motor and it should only be connected
to a 120-volt, 60 Hz AC ONLY power supply (normal household current). The trimmer
should always be used with a GFCI (Ground Fault Circuit Interrupter) outlet.
DO NOT operate this trimmer on direct current (DC). The large voltage drop would cause
a loss of power and the motor would overheat.
If the trimmer does not operate when plugged into correct 120-volt, 60 Hz AC ONLY outlet,
check the power supply. The trimmer comes with a 12-in. pigtail power cord and should
be plugged into a proper extension cord (see page 6).
PIGTAIL POWER CORD (Figs. 2, 2a and 2b)
__._\,
Fig. 2a
Fig. 2b
__
Fig.2
Hook
Remove the plug guard from the pigtail power cord (see Fig. 2). Make a loop in the
extension cord. Push loop through hole above retension hook (see Fig. 2a). Fasten loop
around cord retention hook, and pull the cord back. Plug trimmer's power cord into extension
cord plug (see Fig. 2b).
Safety, performance
and dependability
have been given top priority in the design of
this product, making it easy to maintain and operate.
This Electric Trimmer has the following
features:
4.
5.
6.
7.
1.10=inch Cutting
Path
2.2.2 Amp Electric
Corded / 11,000 RPM (no=load speed) motor for efficient trimming.
3. Ergonomically
Designed
Front Auxiliary Handle and Rear Handle for maximum
control and gripping comfort with reduced operator fatigue.
Finger Trigger
Switch with Safety "On" Button. Safety On button must
be depressed to operate trigger switch.
Lightweight and Ergonomically
Designed for easy use, handling comfort and
efficient trimming.
Bump=Feed Head allows you to simply bump the trimmer head to advance cutting line.
Your Trimmer uses Nylon monofilament
round single-wound 0.065 inch line.
For Cutting-Line
Replacement: Re-load spool with Craftsman line Item 71-85822,
15 ft. bulk pack of Craftsman .065 line (sold separately).
10
11
Advertisement
