Advertisement
ACCESSORIES
These accessories were available when this lawn mower was produced. They are also available at most Sears retail outlets,
catalog and service centers. Most Sears stores can also order repair parts for you, when you provide the model number of
your lawn mower.
Some of these accessories may not apply to your lawn mower.
ENGINE
SPARK PLUG
MUFFLER
AIR FILTER
GAS CAN
ENGINE OiL
STABILIZER
LAWN MOWER MAINTENANCE
BELT
BLADE
BLADE
ADAPTER
WHEELS
LAWN MOWER
COVER
ASSEMBLY
Read these instructions and the Operator's Manual in its
entirety before you attempt to assemble or operate your
new lawn mower.
Your new lawn mower has been as-
sembled at the factory with the exception of those parts left
unassembted for shipping purposes. All parts such as nuts,
washers, bolts, etc., necessary to complete the assembly
have been placed in the parts bag. To ensure safe and
proper operation of your lawn mower, all parts and hard-
ware you assemble must De tightened securely.
Use the
correct tools as necessary to ensure proper tightness.
TO REMOVE
LAWN MOWER FROM
CARTON
-
Remove loose parts included with mower.
•
Cut down two end corners of carton and lay end panel
down flat.
-
Remove all packing materials except padding between
upper and lower handle and padding holding operator
presence control bar to upper handle,
•
Roll lawn mower out of carton and check carton thor-
oughly for additional toose parts.
HOW TO SET UP YOUR LAWN
MOWER
TO UNFOLD
HANDLE
(See Fig. 1)
Raise handles until Power handle section locks into
place in mowing position.
OPERATOR
PRESENCE
CONTROLBAR
UPPER HANDLE
LIFT UP
MOWING
POSITION
LOWER HANDLE
FIG. 1
Raise upper handle section intoplace on lower handle,
remove protective padding and tighten both handle
knobs.
Remove handle padding holding operator presence
control bar to upper handle.
,
Your lawn mower handle can be adjusted for your
mowing comfort.
Refer to "Adjust
Handle" in the
Service and Adjustment section of this manual.
Advertisement
