Audio System (Models Without Navigation System) - Honda Civic 2-Door Owner's Manual

Audio System (Models without navigation system)

Your audio system shows a welcome
message on the display when you
turn the ignition switch to the
ACCESSORY (I) or the ON (II)
position. You can see a message
''WELCOME'' on the display when
your vehicle was new.
You can also customize this welcome
message to your liking with the
audio controls.
To Customize a Message
You can set up to about 16
characters on the display.
To select a character:
1. Make sure the audio system is off.
2. Push and hold the TUNE knob,
then push the power/volume knob
on the audio control panel. You
will see the first letter blinking.
116
POWER/VOLUME
KNOB
EX model is shown.
3. Turn the TUNE knob to change a
letter.
4. Push the top of the SEEK button
to select the next segment, then
turn the TUNE knob to select a
letter. Repeat this procedure to set
your message.
TUNE KNOB
SEEK BUTTON
To change the letter, select the
previous segment by pushing the
bottom of the SEEK button.
The system will return to the audio
display about 5 seconds after you
stop selecting a letter.