Advertisement
Quick Links
1
Prepare the Reservoir:
Fill
Replace the
reservoir onto the base,
PRESSING DOWN FIRMLY
to ensure full seating.
3
Prime Unit (First Time Use Only):
Prior to Very First Use of Unit, Prime Unit:
Set pressure control slide switch on handle
to high, point the handle and tip into sink.
Turn unit
ON
until water flows from the handle,
OFF.
turn unit
High
QUICK START GUIDE
Remove the reservoir
from base and fill with
lukewarm water.
Replace
Model WP-60/65/70
2
Select and Insert Tip:
Insert
4
Adjust Pressure and Pause Control:
For first time
users, adjust
pressure control
to
lowest position.
Gradually increase
pressure as you
prefer.
Low
No
Gap
Press tip firmly into
handle. When tip is
properly inserted there
should be no gap between
control knob and tip. To
remove tip, simultaneously
hold control knob down
and lift tip up.
You can temporarily stop
water flow by pressing
the pause button on the
handle.
PAUSE
continued
on back
Advertisement
Summary of Contents for Waterpik Technologies WATERFLOSSER WP-60
- Page 1 Model WP-60/65/70 QUICK START GUIDE Prepare the Reservoir: Select and Insert Tip: Remove the reservoir Fill from base and fill with lukewarm water. Press tip firmly into Replace handle. When tip is Insert properly inserted there should be no gap between Replace the control knob and tip.
- Page 2 Using your Waterpik Water Flosser: ® Always place tip in mouth before turning unit on. Lean over sink and close lips enough to prevent splashing, while still allowing water to flow from mouth into the sink. PAUSE Turn unit ON. PAUSE Always turn unit...