Advertisement
7) Dry Timer (50728)
Replacement Procedure:
▪
Unplug the unit.
▪
Remove the top panel (Two screws behind and slide back)
▪
Pull out the soap dispenser, plastic washer knob and dryer knob.
▪
Remove the control panel. (3 Screws)
▪
Unfix the two screws that hold the dry timer and take out the timer.
▪
Pull out all the wires on the dry timer and replace the same.
▪
Fix all the parts back by following the reverse procedure.
Wiring: Dry Timer
TAB
TAB1
TAA1
TAA
Testing Procedure:
▪
Cold
Test:
1) Turn the dryer knob to 30 and check for continuity between terminals a & a1, b & b1.
2) Check the resistance between TAC and a terminals, it should not be more than 2300
ohm.
Please Note: The side with b & b1 should be on the top.
b
b1
a1
a
18
TAC
Advertisement
