Craftsman WEEDWACKER C944.514361 Instruction Manual page 8

• The tipofthe line does t he cutting.
You will a chieve the best perform-
ance and minimum line wear bynot
crowding the line into the cutting
area. The right and wrong w ays a re
shown b elow.
Tip of t he Line I Line C rowded into
Does The C utting W ork Area
Right " "<_1 Wrong
• The line will easily remove grass
and weeds from around walls,
fences, trees and flower beds, but it
also can cut the tender bark of trees
or shrubs and scar fences. To help
avoid damage especially to delicate
vegetation or trees with tender bark,
shorten line to 4-5 inches (10-13
cm) and use at less than full throttle.
• For trimming or scalping, use less
than full throttle to increase line life
and decrease head wear, especially:
• During light duty cutting.
• Near objects around which the line
can wrap such as small posts,
trees or fence wire.
• For mowing or sweeping, use full
throttle for a good clean job.
TRIMMING - Hold the bottom of the
trimmer head about 3 inches (8 cm)
above the ground and at an angle. Al-
low only the tip of the line to make
contact. Do not force trimmer line into
work area.
Trimming . : .
incnes (8 sin) ," _\
above ground ,_ = _'
SCALPING - The scalping technique
removes unwanted vegetation down
to the ground. Hold the bottom of the
trimmer head about 3 inches (8 cm)
above the ground and at an angle. Al-
low the tip of the line to strike the
ground around trees, posts, monu-
ments, etc. This technique increases
line wear.
Scalping .....
MOWING - Your trimmer is ideal for
mowing in places conventional lawn
mowers cannot reach. In the mowing
position, keep the line parallel to the
ground. Avoid pressing the head into
the ground as this can scalp the
ground and damage the tool.
Mowing I_
SWEEPING - The fanning action of
the rotating line can be used for a
quick and easy clean up. Keep the
line parallel to and above the surfaces
being swept and move the tool from
side to side.
Swe_.. .....
_-=--=T-. _ _,,r.; _ \