Specifications; Lawn Mower - Craftsman 917.377911 Owner's Manual

PRODUCT SPECIFICATIONS
MODEL NUMBER 917.377911
SERIAL NUMBER
DATE OF PURCHASE
HORSEPOWER:
GASOLINE CAPACITY/TYPE:
OILTYPE (API-SF/SG/SH):
OIL CAPACITY:
SPARK PLUG(GAP: .030")
VALVE CLEARANCE:
SOLID STATE IGNITION
t_lR GAP: .0125 IN.
BLADE BOLT TORQUE: 35-40 FT. LBS.
6.75
1.25 QUARTS
UNLEADED REGULAR
SAE 30 (ABOVE 32°F)
SAE 5W-30 (BELOW 32°F)
20 OZS.
CHAMPION RJ19LM or J19LM
INTAKE: .004 - .008
EXHAUST: .004 - .008
The model and serial numbers will be found on a decal attached to the rear of the
lawn mower housing.Record both serial number and date of purchase in space
provided above.
LAWN MOWER
Always observe safety rules when performing
any maintenance.
TIRES
Keep tires fTee of gasoline, oil, or insect
control chemicals which can harm rubber.
• Avoid stumps, stones, deep ruts, sharp
objects and other hazards that may cause
tire damage.
BLADE CARE
For best results, mower blade must be
kept sharp. Replace bent or damaged
blades.
TO REMOVE BLADE
• Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug.
• Turn lawn mower on its side. Make sure
air filter and carburetor are up.
• Use a wood block between blade and
mower housing to prevent blade from
turning when removing blade bolt.
• Protect your hands with gloves and/or
wrap blade with heavy cloth.
• Remove blade bolt by turning counter-
clockwise.
Remove blade and attaching hardware
(bolt, lock washer and hardened
washer).
NOTE: Remove the blade adapter and
check the key inside hub of blade adapter.
The key must be in good condition to work
properly. Replace adapter if damaged.
TO REPLACE BLADE
Position the blade adapter on the engine
crankshaft. Be sure key in adapter and
crankshaft keyway are aligned.
Position blade on the blade adapter
aligning the two (2) holes inthe blade
with the raised lugs on the adapter.
Be sure the trailing edge of blade
(opposite sharp edge) is up toward the
engine.
Install the blade bolt with the lock
washer and hardened washer into blade
adapter and crankshaft.
Use block of wood between blade and
lawn mower housing and tighten the
blade bolt, turning clockwise.
The recommended tightening torque is
35-40 ft. Ibs.
IMPORTANT: BLADE BOLT IS GRADE 8
HEATTREATED.
12