Kenmore IntelliSoft 370 Series Owner's Manual page 65

INSTALL COVERS
After installing your water softener, replace the covers. Angle
the covers so the main cover clips onto the back first, then
bring down in front and clip on the two (2) tabs inside the rim
of the salt hole and lower the salt cover closed. See Fig. 23.
RESTART THE WATER HEATER
Turn on the gas (or electric) supply to the water heater and
light the pilot.
YOUR PLUMBING INSTALLATION AND ELECTRICAL
WORK ARE NOW COMPLETE.
Cover
(Main)
Salt Hole
Cover
FIG. 23
Salt Level Adjust Display
REGENERATION Button
UP Button
Signal Light
Adjust
DOWN Button
Tank Light
PROGRAM THE TIMER
1. When the transformer is plugged in, a model code
(H 32), and a test number (example: J1.1) show in the
face plate display for 4 seconds. Then, 12:00 AM and
PRESENT TIME begin to flash.
NOTE: If "- - - -" shows in the display, press the UP
or DOWN button until H 32 shows in the display.
Then, press the SELECT button to set, and change
to the flashing PRESENT TIME display.
8
2. To check the model code, unplug the transformer at the
wall outlet and plug in again. If other than H 32 shows,
refer to the Troubleshooting Section.
SOUND "BEEPER": A "beeper" sounds while pressing
buttons for timer setup. One beep signals a change in
the face plate display. Repeated beeps mean the timer
will not accept a change from the button you have
pressed, telling you to use another button. For example,
while setting the hardness the beeper sounds repeated-
ly when the display reaches 1 using the DOWN button,
or the highest hardness setting using the UP button.
SELECT Buttons
H 77
-qE
I I I
-J I, I
FIG. 24
- -8- - JC'UU
PRESENT TIME
FIG. 25
Questions? Call The Kenmore Water Line 1-800-426-9345
17