Connecting The Projector To A Computer - Sharp Notevision XG-C50X Operation Manual

Connecting the Projector to Other Devices

Connecting the Projector to a Computer

Connecting to a Computer
Using the RGB Cable
1
Connect the projector to the
computer using the supplied
RGB cable.
• Secure the connectors by tightening
the thumbscrews.
2
To input audio signal, connect
the projector to the computer
using the supplied computer
audio cable.
Note
• See page
93 "Computer Compatibility
Chart" for a list of computer signals com-
patible with the projector. Use with com-
puter signals other than those listed may
cause some of the functions not to work.
• When connecting the projector to a com-
puter in this way, select "RGB" for "Signal
Type" in the "Picture" menu. See page 46.
• A Macintosh adaptor may be required for
use with some Macintosh computers. Con-
tact your nearest Sharp Authorized
Projector Dealer or Service Center.
• Depending on the computer you are us-
ing, an image may not be projected un-
less the signal output setting of the com-
puter is switched to the external output.
Refer to the computer operation manual
for switching the computer signal output
settings.
Connecting the thumbscrew cables
■ Connect the thumbscrew cable making sure that
it fits correctly into the terminal. Then, firmly se-
cure the connectors by tightening the screws on
both sides of the plug.
■ Do not remove the ferrite core attached to the RGB
cable.
-18
Supplied
accessories
Notebook computer
To RGB output terminal
To audio output terminal
Ferrite core
RGB cable
Computer audio
cable
1
RGB cable
2
Computer audio cable